24
These values refer to the internal network you are creating with
this Router. Unless you have specific internal needs or in the
router mode, there should be no requirement to change these
values.
Note:
(1) Check with your ISP to see if you need to enter Router &
Domain Names to be viewed by your ISP's network.
(2) If you do, click on the
Start
button. Choose
Control Panel
,
then double-click the
Network
icon.
(3) Choose the Identification tab. There will be a Computer Name
and a Workgroup name displayed here.
(4) Enter the Computer Name into the Router Name box on the
Setup Page, and enter the Workgroup name into the Domain
Name box on the Setup Page.
3. Click
Next
box go to
Step 3
. These values refer to the outside
network you connect to every time you access your Broadband
Internet connection.
25
Most ADSL ISPs assign their clients with a different IP address via
PPPoE or PPPoA each time they log on. If this is the case with
your ISP, you should set PPPoE+NAT or PPPoA+NAT mode at
previous
Step 1
. You can setup PPPoE or PPPoA activity time, the
router will log off when the idle time up.
6. You should check with your ISP for VPI/VCI and AAL5
Encapsulation for ATM VC parameter if you select PPPoE or
PPPoA mode.
7. You should give user's name and password if you select
PPPoE+NAT or PPPoA+NAT mode in
Step 1
.
