MicroNet InTagral Plus, User Manual

Page: 69 / 70

InTagral™ Plus
Time & Attendance Clock
Page 5-9
5.6.1. Visible Installation
For visible installation, perform the following:
1. In this installation the cable that connects the external reader to the clock
unit is visible.
2. Mark 4 holes, supposed to be drilled, with the help of the Reader back
side (Item No 1)
3. Hang the reader back side on the wall with the screws (not supplied in the
existing Set)
NOTE
The external reader has one way closing, therefore it is recommended to set slot “A” downwards.
4. Connect the cable (Item No 3) to J1 connector on the main board (look
Item No 2)
a. Tie the cable (Item No 3) to slot “A” that exist in the box parietal
b. Tie both sides of the reader with the help of the 4 screws (Item No 4)
5. Connect the cable to the connector circled in Picture 1.
6. Disconnect the communication cables from the clock (do not disconnect
the power supply). Make sure the clock does not show the message
‘Wait’ , then reset the clock (see Paragraph 3.5) in order to activate the
external reader option.
7. Check the external reader functionality by swiping several suitable cards.
8. Connect the communication cables to the clock and hang it back on its
cradle.
9. When the external reader functions, attach the label to the front side of
the reader (Item No 5), notice that the description on the label is not
reverse. Be careful, Label should be detached and may be destroyed to
open the reader box again.
10. Tie the cable to the wall to avoid unnecessary swings.