Electrical Characteristics
Device DC power (+12V and +5V) is through the standard SAS interface. Typical power
measurements listed below are based on an average of drives tested, under nominal
conditions, using the listed input voltage at 60°C internal temperature. Measurements
are made at 12Gb interface speeds.
• Startup power: Measured from power-on to when the drive reaches operating condi-
tion and can process media access commands.
• Peak operating mode power: Measured by testing the drive in various read and write
access patterns that simulate worst case power consumption.
• Idle mode power: Measured when the drive is powered up and ready for media access
commands, but before the host has sent the commands.
Note:
Stresses greater than those listed in the following tables may cause permanent
damage to the device. These are stress ratings only and device operation above ratings
or conditions listed in the operation sections of this specification is not implied. Expo-
sure to absolute maximum rating conditions for extended periods may affect reliability.
S600DC Series 2.5-Inch SAS NAND Flash SSD
Electrical Characteristics
CCMTD-1725822587-3891
s600dc_series_2_5_sas_ssd.pdf - Rev. H 9/17 EN
29
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2015 Micron Technology, Inc. All rights reserved.
