INSTALLATION
The drill mechanics must be securely mounted on a flat, rigid surface in order to maintain
the machine's accuracy.
Electrical supplies should be from a direct connection to the main power source of the
building with no other equipment of any kind connected to the same line.
A good electrical ground connection must be made to the machine both to reduce electric
shock hazard and to help prevent electrical disturbances from affecting the operation of the
machine. In some areas it may be necessary to use a power supply filter / regulator unit to
prevent power line interference.
Power requirements:
Electrical Supply 220-230 VAC, 47-63 Hz., single phase @ 10 Amps
Compressed air must be clean and dry and regulated to not more than 80 p.s.i. (5.5 bar)
Although the Micromat will operate under a wide variety of conditions, the machine must
not be subjected to extremes of temperature as this will obviously affect its accuracy.
Temperature changes will also affect the size of any laminate being used. Normal operation
should be at or about 65 degrees Fahrenheit (18 degrees Celsius).
INTERCONNECTIONS
2
