Page 14
Press the Enter Key when done.
When the reference dimension is entered as above, you can remove the reference object and
measure any item at that distance from the optics (lens) in either the X, Y or diagonal directions.
Adding a unit of measure
You may also wish to add a unit of measure to your dimension display. The following procedure
is used to add a unit of measure to the dimension display:
Press the SET button to bring up the SCALE and UNIT PARAMETERS menu.
Press 4 to access the SELECT UNIT menu.
Press 1 to use a metric unit, 2 to use a US unit or 3 to use a custom unit. If you need to set a
custom unit first, press 4 and follow the procedure in the section describing custom
units.
Next press number 1 through 8 to choose the appropriate unit of measure.
Press 0 twice to exit (once to return to the Scale and Unit Parameters Menu and the second
time to exit the menus).
Saving the current configuration
Once you set a calibration, you may want to store it in memory for use later, so you don’t have
to keep re-calibrating for the same zoom or magnification factor. You can save the data in one
of ten memories by doing the following:
Memory Store
Set the cursors and scale for your application
Press the STORE key (the indicator should illuminate)
Press a number (0 through 9) to select one of the ten memory locations (indicator should
extinguish after pressing the number)
Within five seconds the state of the machine will be saved to that memory number, even after
power is turned off.
Memory Recall
To recall from memory, press the RECALL key followed by a number key (0 thru 9) relating to
the memory you wish to recall from.
