Page 9
surfaceCONTROL 3D SC2500 / SC2510
10.
Operating Programs
Various programs are provided for operation of the sensor.
- 3DInspect solves industrial 3D measurement tasks.
- You can use surfaceCONTROL DefMap3D, including the dongle which is subject to a
charge, for the analysis of individual surfaces with surfaceCONTROL 3D 25x0.
11.
Installation
Requirements
The following minimum system specifications are necessary for the use of the operating
programs:
- Windows 10 (64 bit)
-
≥ 2
GHz processor (64 Bit) or higher
- 4 GB RAM
- Screen resolution: 1280 x 1024
- Graphics card/GPU with OpenGL 3.1 or higher
The following procedure is necessary in order to install the software:
1. Install the hardware of the Ethernet interface(s) if not present.
2. Install the software.
3. With DefMap3D: use the USB dongle required for this.
4. Connect the controller of the surfaceCONTROL 3D 25x0 measuring system to the PC
via Ethernet. Do not use hubs.
i
If your network card supports the VLAN option, this option must be disabled.
Connecting surfaceCONTROL 3D 25x0 to the PC
To connect surfaceCONTROL 3D 25x0 via Ethernet to the PC, proceed as follows:
1. Complete the installation of the software.
2. Connect surfaceCONTROL 3D 25x0 to the PC using the Ethernet interface.
3. Turn on the power supply.
3. Wait until the surfaceCONTROL 3D 25x0 measuring system is recognized by the PC.
This takes about 1 minute.
i
To be able to operate the measuring system, the controller and the PC must be
located in the same subnet.
The sensor starts in DHCP mode. If there is no DHCP server in the network or if no ad-
dress has been assigned manually, the sensor and network adapter assign themselves an
address (Link Local Address).
You can now operate the surfaceCONTROL 3D 25x0 measuring system using the operat-
ing programs listed above.
