Page 5
Safety
surfaceCONTROL 2500
1.
Safety
System operation assumes knowledge of the operating instructions.
1.1
Symbols Used
The following symbols are used in these operating instructions:
CAUTION
Indicates a hazardous situation which, if not avoided, may result in
minor or moderate injury.
Indicates a situation that may result in property damage if not
avoided.
Indicates a user action.
i
Indicates a tip for users.
Measure
Indicates hardware or a software button/menu.
1.2
Warnings
Do not look directly into the light source of the sensor.
> Risk of injury, damage to the eyes and skin
Connect the power supply and the display/output device according to the safety regula-
tions for electrical equipment.
> Risk of injury
> Damage to or destruction of the sensor
The supply voltage must not exceed the specified limits.
> Risk of injury
> Damage to or destruction of the sensor
Avoid shocks and impacts to the sensor.
> Damage to or destruction of the sensor
The air inlets and outlets of the sensor must be kept clear and must not be covered
> Damage to or destruction of the sensor
Do not touch the lenses with your fingers. Remove any fingerprints immediately with
pure alcohol and a clean cotton cloth without streaks.
> Damage to or destruction of the sensor
Never kink the cables and do not bend in small radii.
> Damage to or destruction of the cable; failure of the sensor
Protect the cables against damage
> Failure of the sensor
Avoid continuous exposure to splashes of water on the sensor.
> Damage to or destruction of the sensor
The sensor housing may only be opened by authorized persons.
> Damage to or destruction of the sensor
Only plug in or disconnect attached devices when disconnected from the power supply.
CAUTION
