Page 23
Liability for Material Defects
surfaceCONTROL 2500
6.7
Cleaning
6.7.1
Housing
It is not recommended to clean the housing. But if cleaning needs to be carried out, this
can be done using water without additives and a soft cloth.
6.7.2
Protective Glasses / Filter
The lenses of the cameras and the projector are protected as standard by protective
glass filters screwed onto the lenses. We recommend cleaning the protective filters regu-
larly.
Dry cleaning
You can use an anti-static brush for lenses, or blow down the covers using dehumidified,
clean, oil-free compressed air.
Wet cleaning
Use a clean, soft, lint-free cloth or a lens cleaning tissue and pure alcohol (isopropanol)
to clean protective covers.
Never use commercial glass cleaners or other cleaning agents.
When cleaning the protective filters, make sure that you do not change the settings of
the lenses and do not exert any strong pressure on the cameras or the lenses.
> Recalibration is possibly required
7.
Liability for Material Defects
All components of the device have been checked and tested for functionality at the fac-
tory. However, if defects occur despite our careful quality control, INB Vision AG or your
dealer must be notified immediately.
The liability for material defects is 12 months from delivery. Within this period, defective
parts, except for wearing parts, will be repaired or replaced free of charge, if the device
is returned to INB Vision AG with shipping costs prepaid. Any damage that is caused by
improper handling, the use of force or by repairs or modifications by third parties is not
covered by the liability for material defects. Repairs are carried out exclusively by INB
Vision AG.
Further claims can not be made. Claims arising from the purchase contract remain unaf-
fected. In particular, INB Vision AG shall not be liable for any consequential, special, indi-
rect or incidental damage. In the interest of further development, INB Vision AG reserves
the right to make design changes without notification.
For translations into other languages, the German version shall prevail.
8.
Service, Repair
If the sensor or the cable harness is defective,
please send the affected parts back for repair or
exchange. Where the cause of a fault cannot be
precisely defined, always send the entire sensor to:
INB Vision AG
Brenneckestraße 20, ZENIT II
39118 Magdeburg / Germany
Tel. +49 (0) 391 / 6117-300
Fax +49 (0)391 / 6117-301
[email protected]
www.inb-vision.com
9.
Decommissioning and Disposal
Remove all cables from the sensor.
Incorrect disposal may cause harm to the environment.
Dispose of the device, its components and accessories, as well as the packaging
materials in compliance with the applicable country-specific waste treatment and
disposal regulations of the region of use.
