Page 17
Installation and Mounting
optoNCDT 1402
Installation and Mounting
5.
The sensor is an optical sensor for measurements with micrometer accuracy.
i
Make sure it is handled carefully when installing and operating.
Sensor Mounting
5.1
Mount the sensor via 2 screws M4.
Mount the sensor in such a way that
the laser beam is directed perpendic-
ularly onto the surface of the target.
In case of misalignment it is possible
that the measurement results will
not always be accurate, see also
Chap. 9.
Minimum bending radius PC1402-x
once: 39 mm
-
continuous: 78 mm
-
Rotate the connector:
Loosen the 4 screws M2 and rotate
the male connector.
Fasten the male connector. Use new
sealing screws M2. Connector is
sealed (IP67) waiting 12 hours.
Dimensions ILD1402, mm (inches),
Fig. 4:
12
(0.47)
14 (0.55)
20 (0.79)
5 (0.20)
40 (1.57)
50 (1.97)
65 (2.56)
4
(0.16)
65 (2.56)
57 (2.24)
16
(0.63)
Laser spot
80 (3.15)
M12x1
2 Mounting holes
ø4.3/5.8
possible
connector
orientation
48 (1.89)
