MICRO-EPSILON boreCONTROL, Instruction Manual

Page: 11 / 20

Page 11
Mounting
boreCONTROL
Rotation Unit BCM2410 4.4.2
Connect the controller (connector “Sensor“) with the rotation unit. Please use the
SC2410-03 cable.
+24V DC GND
RS232
IFC Sensor
bore CONTROL
Rotation unit connect to the boreCONTROL Fig. 7
IFC 24x1 4.4.3
Connect the controller (connector “IFC“) with the IFC24x1. Use the SC2410-0,5
cable.
bore CONTROL
Sensor
+24V DC GND RS232
SyncIn / T
rigIn
GN
D
Shield SyncOut GN
D
Er
ror 1
GN
D
Shield Er
ror 2
GN
D
HLL 24 VDC GN
D
Shield U out GN
D U
Shield I out GN
D I
Power Digital I/O RS422 Encoder Analog Out
confocal DT
Intensity >max
Intensity <min
Intensity ok
Out of range
Midrange
In range
Power On
External light
source
Status In
Ethernet External
light source Sensor
RS422 Encoder
Dark reference
STATUS
IFC
Sensor controller connected to the boreCONTROL Fig. 8
RS232 4.4.4
Connect the controller (connector “ RS232“) with the PC. Use a standard interface
cable.
PIN No.
9-pin Sub-D
Assignment
+24V DC GND
RS232
IFC Sensor
bore CONTROL
USB 3/4
USB 5/6
Digital I/O
Analog I/O
Firewire / IEEE139
4
1 2 3
USB 1/2
COM1
Power
IPC-4
VGA
LAN1
LAN2
DVI
Relais Remote
2 TxD
3 RxD
5 GND
Via the RS232 interface, the instruc-
tions of the motor control are trans-
ferred to the rotation unit.
Baud rate: 9.6 kBaud. Data format:
8 data bits, no parity, one stop bit
(8,N,1).
The reference grounds (GND) of con-
troller and receiver (e.g. PC or PLC)
must be connected.