Cermet II User’s Manual
Michell Instruments
3
INSTALLATION
2.1.1 Unpacking the Cermet II Transmitter
On delivery, check that all the following standard components are in the packing tube:
•
Cermet II Transmitter
• Bonded
Seal
• Certi
fi
cate of Calibration
Unpack the dew-point transmitter tube as follows:
7
6
5
3
4
2
1
Figure 2
Transmitter Unpacking Method
1.
Unscrew the cap (1) from the packing tube (7).
2.
Remove the foam block (2).
3.
Pull out the transmitter (4) from the tube, complete with the two foam
covers (5) and (6) and the red protective cap (3).
4.
Remove the foam covers from the transmitter but leave the blue plastic
protective cover (4) and the red cap (3) in place until ready for installation.
NOTE: The transmitter sensing element is protected while in transit by a blue
cover containing a small desiccant capsule. The connection pins are protected
by a red plastic cap. None of these plastic items are required for the operation
of the transmitter.
