Cermet II User’s Manual
Michell Instruments
13
INSTALLATION
2.7 Monitor
Mounting
The monitor is designed for panel mounting and requires a panel cut-out of 46 x 92mm
(1.8 x 3.6”). The recommended panel thickness is 2 to 5mm (0.08 to 0.2”).
To mount the unit, proceed as follows:
3
2
1
°Cdp
°Fdp
°Cdp
°Fdp
Cerme
t II
Adv
anced Online
©
ª
Setup
Cerme
t II
Adv
anced Online
©
ª
Setup
Figure 12
Mounting the Monitor
1.
Pass the monitor (1) through the front of the panel (2).
2.
Support the monitor and attach mounting
fi
xing brackets onto the
side of the monitor.
3. Tighten
the
fi
xing screw (3)
fi
nger tight, against the back of the
panel.
4.
Ensure that the monitor is sitting
fl
ush to the front of the panel (2)
and tighten the
fi
xing screws evenly against the back of the panel.
Caution: Do not overtighten the screws as this could cause the case to crack.
