Operating instructions iQ-Oval CDS V1-4.docx
page 57 of 66
9.7.5.
Settings
The following functions can only be controlled at the main terminal:
•
Operating mode change. The
“
optional terminal
”
is always in the same
operating mode as the
“
main terminal
”
.
•
Print- and dryer-station setting in
“
Adjust
”
.
•
“
Preheat Pallet
”
in
“
Manually
”
or
“
Automatic
”
.
•
Activation and deactivation of the 2-Job-mode in
“
BasicSetup
”
.
9.7.6.
Starting the production
To start the production first the start button at the “main terminal” must be pressed.
Then within three seconds the start must be confirmed at the “optional terminal” by
pressing the start button there. The start button of th
e “optional terminal” is only
released when start was pressed at the “main terminal” before, this is indicated by a
green shaded start button at the “optional terminal”. In operating mode “Manually” it’s
also possible to start the print cycle by the two foot switches, however the first start
command must come from the terminal. In “Automatic” the production can be paused
by pressing one of the two foot switches.
9.7.7.
Inlet-, Outlet- und Sample-Mode
Inlet-, Outlet- and Sample-mode work in 2-Job-Mode individually for the two sides of
the machine. The buttons are the same as without 2-Job-Mode. After activating one of
the functions you will be asked about the further procedure by the following window:
9.7.8.
Piece counter
When 2-Job-Mode is activated two individual piece counters are available for the two
machine sides. The associated machine side depends on the adjusted machine
direction. If the tables move to the right, the piece counter is associated to the right
side of the display. When tables move to the left, the counters are associated to the
left side.
Both counters can be reset individually (with button “Reset”).
