6
7.4V, 10AH, Lithium battery
Maximum output Voltage up to 10 KV
Voltage under 500 ohm load up to 3.3 KV
Stored energy
0.55 J
Delivered Energy
0.25 J
Unless otherwise stated values are typical and normal production tolerances of ±10%
should be allowed for
4. Installation guide
Positioning the energizer
Install the energizer:
Adjacent to the electric fence
Preferably in the middle of the electric fence and where it will receive the most daily sun
throughout the season
Where a good earth can be obtained
On firm ground away from flooding and out of reach of animals and children (inside a
protective fence, if required). The solar panel should face true north in the southern
hemisphere and true south in the northern hemisphere.
Mounting the energizer
The energizer can be mounted directly onto a 3cm x 2cm wooden batten using the
post-mounting slot at the rear. To mount onto a wooden post screw the batten to the post.
Also available from MGG are 3cm x 2cm plated steel stands.
Connecting to an electric fence
1 Push a 1m to 2m plated earth rod fully into firm ground. Must be plated as electricity will
not pass through rust.
2 Connect the black lead from the Fence earth terminal on the energizer to the earthing
system.
3 Connect the red lead from the Fence output terminal on the energizer to the fence.
Make sure there is a good contact.
Caution! Make sure the connecting leads drop downwards from the energizer to prevent
water from collecting at the terminals.
Operation
Switching on and off
1 When switched on the pulse indicator light flashes once for each output pulse.
2 When switched off the pulse indicator light stops
Battery protection
