MGE UPS SYSTEMS
Pulsar ESV 8+
Rack
/11+
Rack
/14+
Rack
/22+
Rack
: 86-153523-00
13
c.
Vac IN
mains
outlet
5
Network Protection
IN
OUT
1
2
MGE UPS SYSTEMS, Inc.
7b
7a
7
8
getting started
installation
■
observe the safety rules indicated at the
beginning of this document.
preliminary checks
■
check that button
3
"
" on
the front is not pushed in;
■
check that rating shown on identification
plate
10
corresponds to the input volt-
age specification and power requirement of
the load.
connections
■
power connections:
■
■
use the UPS input cord to supply input
power to Pulsar as shown.
■
serial connections:
If you wish to use the functions of the
CD-ROM supplied with your Pulsar, con-
nect one end of the supplied serial cable
14
to the communication port 9 .
Connect the other end to a serial port of a
computer system.
■
computer network protection:
If you wish to use the network line filtering
functions (Ethernet for example), use a
cable of the RJ45 type. Connect the "IN"
output to the network and use another cable
to connect the "OUT" output to the protect-
ed computer system.
Connect the UPS input cord 5
to a near-
by power outlet.
For the ESV8+
Rack
, the input cord is not
attached to the UPS. Connect the input
cord to the UPS input recepticle 4 , as
shown on page 7, and to a nearby power
outlet.
■
■
use included IEC cords
8
to connect
the computer loads to output sockets
7 ,
7a
and
7b
.
Note 1:
Following connection, the battery automatical-
ly charges, regardless of the position of the
ON/OFF button
3
"
" .
Note 2:
The batteries will provide full back-up time
after approximately 8 hours of recharge time.
Note 3:
The rating of the input power cord must not be
less than the nominal input rating of Pulsar.
