43
Model:
Netti Dynamic AdaptPro
Language:
English
Version:
2021-11
My-Netti.com
CORRECT SEAT DEPTH:
Adjust the seat plate and position as described in
chapter 5.4.
Loosen the Velcro straps of the back support. Let the
user sit onto the wheelchair - with cushions mounted.
Check that the user is getting into the chair firmly.
Adjust the back support by pulling the straps of the
Velcro. The knees of the user should align with the
joint of the leg support both in height and in depth.
This will ensure that the user gets a good back support
and pressure distribution under the thighs.
Extension pieces allow for adjustments for different
leg lengths.
5.10.2 CALF SUPPORTS HEIGHT AND
DEPTH ADJUSTMENTS
With both leg supports in correct height, the calf
supports must be adjusted:
HEIGHT ADJUSTMENT:
loosen the two M6 screws with 5 mm Allen key - on
the half-moon brackets - holding the calf pad arm.
This allows the calf support-pad arm to move up
and down. The calf supports should in addition to
supporting the calf also help prevent the feet sliding
backwards from the foot-board.
Choose a height covering the middle and lower part of
the user’s calf and tighten the screws.
Twist the calf pads to an angle giving support for the
leg when the foot support is angled. The calf pads can
swing freely to follow the movements and adjust to
the user’s leg position.
1 pc 5 mm Allen key
DEPTH ADJUSTMENT:
loosen the M8 screw holding the calf pad on the calf
pad arm with 2 pcs 13 mm spanner and slide the calf
pad in or out to desired depth - the calf pad barely
touching the calf while the feet are standing on the
middle of the foot board.
They should in addition to supporting the calf also
help prevent the feet sliding backwards from the
foot-board.
2 pcs 13 mm open end spanner
