4
X
6
3
7
18
Adjusting the arm support to the
wheel circumference
The distance X to the arm support
running parallel to the wheel diame-
ter (X) is to be aligned to the selected
wheel position.
!
Attention:
The distance X between the driving
wheel and the arm support should
be as small as possible (approx. 1
cm). – Danger of crushing!
– Remove drive wheel (see Drive
wheels section).
– Dismantle the screwed connections
(6).
– Position the arm support bracket
(3) to the equalising wheel circum-
ference.
– Assemble screw connections (6).
The arm support can be adjusted in
height at the back support.
☞
Note:
If the simple adjustment is not suf-
fi cient (e.g. with 25“-wheels) the
arm support can be repositioned in
height.
– For this disassemble the rear screws
(7). Reposition the arm support in
height and reassemble the screws
(7).
☞
Note:
After alignment to the wheel cir-
cumference check the functions of
the arm support.
Summary of Contents for FX One 1.150
Page 1: ...GB We move people OPERATING MANUAL ACTIVE WHEELCHAIR FX ONE Model 1 150...
Page 51: ...51 NOTES...
Page 52: ...52 NOTES...
Page 53: ...53 NOTES...
