29
2. Set the selection lever to push
mode. Afterwards lift the drive for-
ward out of the holders on the side
and push backwards (fig. 37).
Reassembly of
SCOOTER
-compo-
nents
☞
Before assembly a visual check of
the single components should be
conducted for completeness and
damages.
Here the following is to be observed
closely:
– The brackets to receive the drive
may not be bent.
– The locking bolt to attach the as-
sembled front panel and drive are
still on the safety wire.
– The connection cables are not dam-
aged.
– The ball is screwed onto the selec-
tion lever.
Attaching the drive unit
First set the drive to push mode.
1. Place the retaining tubes of the
drive onto the holders of the front
section (fig. 38).
2. Lift the drive and the front section
over the seat tube as far as possi-
ble (fig. 39).
38
39
37
