1-800-325-9103
PB-FATBOY
- 13 -
www.meyermfg.com
Safety Precautions For Tractor Towed Units:
•
Do not exceed 20 mph (32 kph). Reduce speed on rough roads and surfaces.
•
Always install a SMV emblem on pull-type equipment when transporting on roadways and keep clean and bright.
•
Always yield to oncoming traffic in all situations and move to the side of the road so any following traffic may pass.
•
Comply with state and local laws governing highway safety and movement of machinery on roadways.
Safety Precautions For Hydraulic System:
•
Check hydraulic tubes, hoses and fittings for damage and leakage. Never use hands to check for leaks. Hydraulic
tubes and hoses must be properly routed and have adequate support and secure clamps. Tighten or replace any parts
that show leakage.
•
Always clean fluid spills. Do not use gasoline or diesel fuel for cleaning parts. Use commercial nonflammable solvents.
5.1.1 Farm Implement Tires
Recommended Safety Precautions
•
Always remove the valve core and deflate the tire before any work is performed.
•
Always use the proper and approved tools to demount and mount the tire.
•
Always inspect all rim/wheel parts for wear, damage, cracks, rust or mismatched components.
•
Always destroy damaged or unserviceable parts.
•
Always inspect the tube and tire for cord or side damage, cuts or wear. Unrepairable damaged items must be
discarded.
•
Always check for mismatched components or tire and wheel sizes.
•
Always lubricate tire with a non-flammable tire lubricant approved for that purpose.
•
Always place tire and wheel in inflation cage or restraining device before inflating beyond 5 PSI.
•
Always use an extension hose with a PSI gauge and clip on chuck when inflating the tire so you can stand to one side.
Non - Recommended Safety Precautions
•
Never work on a tire / wheel assembly before removing the valve core and completely deflating.
•
Never re-inflate a tire that has been run flat or in an under inflated condition before removing and inspection.
•
Never reuse damaged, defective, worn or mismatched parts.
•
Never rework, weld, heat or braze any rim / wheel parts for any reason.
•
Never inflate any tire beyond 40 PSI to seat the beads. If beads are not seated at 40 PSI. STOP! Deflate and determine
problem.
•
Never hammer, strike or pry on a rim / wheel assembly that contains any inflation pressure.
•
Never inflate a tire without using an inflation cage or restraining device.
•
Never inflate beyond the maximum PSI specified for the tire or rim.
Summary of Contents for BOSS RT FATBOY 1026RT RR
