Meyer Sound RMS 4.5, User Manual

Page: 21 / 64

17
CHAPTER 2
8. Remove the plastic connector (next to the fan power
connector) on the power supply board.
9. Apply one drop of Loctite® to each of the four
standoffs on the RMS communications module.
CAUTION:
Be careful to avoid touching any
of the components. Always handle modules
by their edges.
10. Position the RMS communications module within
the bottom of the power supply chassis so that the
standoffs on the module align with the four screw
holes in the bottom of the chassis and the LEDs are
facing out.
11. Connect the short 9-wire gray ribbon cable from the
RMS communications module to the connector on the
power supply board.
NOTE:
Make sure that all of the pins are
engaged and the connector is firmly seated.
plastic connector