3
Installation
Your electrically assisted scooter
was not delivered in a fully assem-
bled and set-up condition. The han-
dlebar was dismantled for lack of space. This
work is relevant to safety. Please contact your
specialist dealer for the safe assembly of the
handlebar.
You need to use a torque wrench, if
you want to assemble the handlebar
yourself! While tightening the screws,
it is imperative to comply with the exact torque
of 5 Nm.
Assemble handlebar
1. Remove all packaging.
2. Loosen the hook-and-loop fastener of the
transport safety device.
3. Place the cable clip with the clearance hole,
which the cables run through, onto the han-
dlebar mount of the stem. Position it onto the
thread hole front right in the direction of travel.
4. Place the handlebar with the clamp plate into
the stem mount.
5. Position the handlebar in the middle of the
clamp. Make sure that all cables and wires
are positioned correctly. They must not be
clamped or buckled. The cables must not wind
around the handlebar. They must allow for all
necessary steering movements.
Information on electrics and
electronics
Information on the operation, main-
tenance and care as well as techni-
cal data can be found in these in-
structions and online on the website of the
respective component manufacturer.
The electrical system of your Metz
moover is very powerful. Please al-
ways contact your specialist dealer
for any questions regarding repairs or if you
have a question or problems or discover a de-
fect. The lack of expertise can lead to serious
accidents and damages!
Prior to performing any work on your
Metz moover, switch off the electri-
cal system.
If your Metz moover does drive off
immediately although an error mes-
sage was not displayed, check
whether both brake levers are in the home
position! Motor power is not transmitted if
the brake lever is actuated!
