APT
– User’s Manual
Rev.C_11/19/13
13
5. INSTALLATION FOR USE – LEG EXERCISE
Step 1:
Position the
APT
on the floor close to an electrical socket outlet (Figure 10).
For the
APT Hi-Lo
: loosen the height securing knob (Figure 1A-7, pull the grey ring of the height release
knob (Figure 1A-6) and adjust the unit to the required height.
Step 2:
Loosen the angle-securing knob (Figure 10-1) and adjust the
APT
to the required angle. To increase the an-
gle, lift the body of the
APT
, allow it to “click” into one of the operating positions and retighten the securing
knob. To decrease the angle, pull the angle release knob (Figure 11), lower the body of the
APT
, allow it to
“click” into another operating position and tighten the securing knob.
CAUTION: Make sure that the minimum distance between crank arm and the floor surface is approx-
imately 5 cm. / 2” (Figure 10-2)
Step 3:
Place a chair at the desired distance from the
APT
. If necessary, attach the Securing straps (Figure 10-6) be-
tween the
APT
base rings (Figure 10-5) and the chair legs to prevent any change in distance between the
APT
and the chair during leg exercises.
