APT
– User’s Manual
Rev.C_11/19/13
11
4. INSTALLATION FOR USE – ARMS EXERCISE
Step 1:
Position the
APT
on a level table top close to an electrical socket outlet (Figure 5).
For the
APT Hi-Lo
: loosen the height securing knob (Figure 1A-7, pull the grey ring of the height release
knob (Figure 1A-6) and adjust the unit to the required height. Release the grey ring and tighten the height
securing knob (Figure 1A-7).
Step 2:
Loosen the angle-securing knob (Figure 5-1) and adjust the
APT
to the required angle. To increase the an-
gle, lift the body of the
APT
, allow it to “click” into one of the operating positions and retighten the securing
knob. To decrease the angle, pull the angle release knob (Figure 6), lower the body of the
APT
, allow it to
“click” into another operating position and tighten the securing knob.
CAUTION: Make sure that the minimum distance between crank arm and the table surface is approx-
imately 5 cm. / 2” (Figure 5-2).
Step 3:
Connect the output connector (Figure 7-1) of the power supply (Figure 7-4) to the
APT
power input socket
(Figure 7-2) while ensuring correct position of connector groove opposite the guide key of socket (Figure 7-
3).
NOTE:
The
APT
must be used only with an original
APT
Power Supply unit.
