6 N1 70 en
15
Step 6.
The fit between cylinder tube (4) and rear cover (10)
is very tight. Use screwdriver as crowbar to remove rear
cover (10) from cylinder tube (4), remove rear cover from
cylinder tube.
Step 7.
When removing cylinder tube (4) off of piston (6),
tilt respect to actuator centerline, remove cylinder tube
from piston (6) and front cover (3).
Step 8.
Unscrew hex. soc. Head cap screw and remove it
from piston (6) and piston rod (9).
Step 9.
Remove piston assembly (6) from tie rod.
Step 10.
Remove retaining ring (50) of guide bushing to
remove guide bushing.
Step 11.
Remove guide bushing (7) from opposite side of
piston.
Step 12
. Remove tie rod (8) from front cover. To remove tie rod
use two lock nuts assemble them on tie rod and tight them
with each other then turn one lock nut to remove tie rod.
CAUTION:
Do not damage o-ring grove when removing rear cover
from cylinder tube.
NOTE:
Use cover taping hole for lifting.
CAUTION:
No not damage seals of guide bushing (7) while removing
piston assembly (6).
NOTE:
Use piston taping hole for lifting.
Summary of Contents for Neles N1 Series
Page 35: ...6 N1 70 en 35 ...
