DRIVING INSTRUCTIONS
16
D100014616-EN
398 0 EN 2021-06-22
DRIVING INSTRUCTIONS
1
3
4
2
Figure 21: Fuel level
6. Start the engine by pressing and holding the Engine start/stop button. The machine gives an acoustic
warning signal before it starts. Release the Engine start/stop button when the engine is running.
If the engine does not start, see “Troubleshooting”.
Figure 22: Engine start/stop button
7. Allow the engine to idle until it has warmed up.
8. Check around the engine compartment area for engine oil, fuel, coolant, or hydraulic fluid leaks.
1.8. CONNECTING THE CONTROL DEVICE
Proceed to either of the two sections below depending on the control method you want to use:
• “Connecting the drive control device”
• “Connecting the radio control device”
1.8.1. CONNECTING THE DRIVE CONTROL DEVICE
1. Locate the drive control device.
You can find the drive control device in a tool box (in the middle part the machine), or in the engine
module of the machine.
2. Visually check that the drive control device or the cable is not damaged.
3. Connect the drive control device cable into either of the cable connecting sockets. There is one at the
front of the machine (1), and the other one at the rear of the machine (2).
