19
H - Assemble the satellite dish on the
motor
• Assemble the satellite dish and fix it on the
motor’s stem. The satellite dish U-Bolt must be
as low as possible on the stem. As the motor
is at 0°, make sure you perfectly align the dish
offset arm with the motor (diagram H1). In order
to prevent the dish from falling down in case
of breakdown of the U-screw of the dish, we
advise you to put the security-bolt (marked 4
on the figure page 15). If this bolt is to short to
maintain the U-screw, link it to the dish with the
help of a strong wire.
• Direct approximately the whole set (satellite
dish + rotor) towards the south. Adjust the angle
on the back support of the dish, so that the dish
is vertical.
• Switch on the receiver.
• Do
a
continuous
rotation
(4)
until the stop
75° East and 75° West
to check if there is no
obstacle. If you get
close from an obstacle
during the rotation, go
to paragraph N page 23
to adjust your electronic
limits.
• Put the receiver on the
Hotbird reference channel.
I - Assembling the LNB head
Check the LNB and receiver user manual.
J - Checking
Before going to the final stage (the alignment) check that
your installation looks like the picture J (exept the cables).
(4)
see related paragraph page 13
H1
OK
WRONG
North
H2
South
J
