METRODATA LTD
WCM1100 / WCM3100 / WCM-Serial
Quick Start Guide
76-02-082 Rev D
32 of 75
This is an example
of a Welcome Banner
Welcome to the WCM
Please enter the password>
password ('view' to view only):
4.1.6 Warm Start
A warm Start will force the WCM to restart and reload the configuration from the EEPROM.
Note, any changes to configuration that have not been saved to the EEPROM will be lost.
When a user issues a warm start request, the WCM will indicate that a warm start is in
progress and then close the connection.
4.1.7 Cold Start
Cold Start will return the WCM to the factory default condition and as defined by the bit
switch settings.
Note, that a cold start will erase IP addresses and Routing Table entries and it is therefore
highly likely that remote access will be lost following a cold start.
For this reason a cold start request must be confirmed before it is actioned, and the user
must type Y at the prompt
Returns all settings to defaults!
Are you sure?
Once confirmed the unit will restart, and default the internal non volatile configuration
memory and return the unit to the default state.
