METRODATA LTD
WCM1100 / WCM3100 / WCM-Serial
Quick Start Guide
76-02-082 Rev D
23 of 75
To change the IP settings for installation:
DHCP
For operation in a DHCP enabled network and automatic
IP address allocation set this parameter to ON to enable
DHCP address allocation.
IP Address
If DHCP is not used, you must manually assign the
required IP address for correct installation into the
network. ( Note the default IP address is set to
169.254.42.42 )
Net mask
If DHCP is not used, you must assign the required network
mask for correct installation into the network.
3.7 Set Default Route
From the Main Setup Menu, select Management, then IP,
Metrodata WCM "" Alarms: Major
IP
default TTL 32
Max reassy time 0 sec
DSCP priority 0
Routing table <display>
Forwarding Disabled
Stats. <display>
First CAPITAL - select item
<escape> - exit menu
then select the Routing Table menu and set the default route,
Metrodata WCM "" Alarms: Major
Destination Next Hop I/f Type Prot. Age Mask
-----------------------------------------------------------------------------
169.254.0.0 0.0.0.0 Mgmt direct local 157 255.255.0.0
A - add entry
D - delete entry
any other key to exit:
Add route.
Destination: 0.0.0.0
Mask: 0.0.0.0
Next-hop: 169.254.0.254
