www.metel.eu 8/23
www.iplog.eu
ETH
ETH events are used for status transmission over the LAN-RING network. Events differ from each other by
a so-called ID identifier in the range of 1 to 999. An ETH event with the same identifier must be set on the
side that sends and receives the event.
Example:
The switch sends the status of input IN1 as an ETH event with ID#87.
Example:
The switch receives ETH events with ID#87, which control the relay.
Menu „Extension/ETH-IO“
The setting of the communication parameters for status transfer between
inputs and outputs is configured in the "Extension / ETH-IO" menu. So-called
multicast packets are used for transmission, which enable the transmission of
information to multiple recipients.
Receive address
- multicast address for receiving packets
Priority -
QoS priority assigned to outgoing packets
VLAN ID
- VLAN tag for sending and receiving packets
Transmit address 1 to 5
- multicast address for sending packets
Application note:
I/O transfer between switches
Event Management - ETH, DIGITAL
DIGITAL
DIGITAL inputs allow you to set automatic actions with digital inputs of switches IN1 and IN2.
DIGITAL MODE
- supported modes
Close
- event is triggered by closing the input (connection of IN to GND)
Open
- the event is triggered by opening the input
Direct
- the input status is sent every 3 seconds. When there is a change, this change is sent immediately
Change
- the event is triggered by closing or opening the input
Example:
Switch on input No. 2 calls up the setting of Preset No. 12 on camera No. 3 (Onvif command).
Menu „Extension/Input/Digital“
Label
-
input naming (stored in the SIMULandv4 project)
Negation
- input negation
Minimal pulse duration (s)
- minimum input on/off length
&
The METEL-COMIO-DIO-MIB file, which also contains SNMP TRAP
permissions, is available for monitoring SNMP inputs.
