?
Once received the freezer, check
that has not suffered any damage.
You should notify your dealer
damage during shipping within 24
hours after delivery.
?
The freezer must be installed in a dry
room that is at a normal temperature
and which has adequate ventilation.
Place the freezer so it will not at any
time obstruct the circulation of air
around it (allow at least 4 cm of free
space).
?
Do not place the freezer in a place
which is exposed to direct sunlight.
Must be installed on a level surface,
and separated from the other hot
objects.
?
If the freezer is stored or transported
in cold, do not restart until the
c o m p r e s s o r h a s r e a c h e d a
temperature of at least +5 ° C. Wash
the freezer before turn on.
?
If the mark on the freezer Figure
Class 04, should not be installed in a
p l a c e w h e r e t h e a m b i e n t
temperature e30 ° C.
?
Freezers Class 4+ can withstand
ambient temperatures of +35 ° C,
and Class 05, up to +40 ° C.
?
In the case of freezers with sliding
doors is very important to be placed
in position so that the bottom is well
covered and thus ensure maximum
insulation. The door should always
be placed so that it can read the text
in the corner of the glass and not the
reverse.
3. INSTALLATION
4. ELECTRICAL
CONNECTION
This appliance complies with EU
requirements for radio electrical
suppression in accordance with
directive Standard 82/499/CEE.
The freezer should be plugged into an
outlet that has the correct voltage and
frequency. These data are specified on
the nameplate located on the back of the
freezer.
The standard voltage in Mexico is 115 V
/ 60 Hz allowed voltage variation + / -
10%. The above variations may cause
damage in the freezer and if so, the
factory warranty would be invalid.
Protection measures must be taken in
addition to using the freezer according
to applicable electrical codes, even in
the case of replacement of existing
freezer that had not been worth the extra
protection needed. The aim of this
additional protection is to protect users
from dangerous electrical shock in case
of failures.
?
To protect your electrical, use a load
center of 25 Amps at 115 Volts.
?
If not possible to obtain the nominal
voltage indicated by a variation of +/-
10% (power supply instability),
install a voltage regulator (1500 VA).
?
Connect the equipment into an
outlet exclusive.
?
The installation must be made only if
the outlet has the nominal output
voltage with a tol / - 10%.
The caliber of the installation cables
must obey the following table:
Caliber
(mm )
Distance
115 V
220 V
2,5
(12 AWG)
4,0
(10 AWG)
6,0
(8 AWG)
10,0
(6 AWG)
UP
19 METERS
20 A 30
METERS
31 A 48
METERS
UP
91 METERS
92 A 145
METERS
146 A 218
METERS
2
The replacement power cords should be
done by an authorized service provider.
PLUG
POLARIZED
TYPE
NEMA 5-15P
PLACEMENT
PROPER
English
4
13
Español
8. MANTENIMIENTO
9. ELIMINACIÓN
Tenga en cuenta las siguientes
recomendaciones relacionadas con la
limpieza del congelador:
Coloque los productos almacenados en
el congelador en un lugar frío o
envuélvalos con un material aislante.
El congelador debe desenchufarse de
la toma de corriente.
?
Mantenga la tapa abierta o extraiga
las tapas deslizantes y colóquelas
en el suelo con cuidado.
?
Limpie el congelador con agua
templada y un detergente suave.
?
N o u t i l i c e d e t e r g e n t e s q u e
contengan cloro.
?
N o h a g a u s o d e u te n s i l i o s
puntiagudos o afilados.
?
Limpie la tapa del congelador del
mismo modo que el interior.
?
Si el congelador incorpora un
condensador y un ventilador en la
parte inferior, puede que se
acumule suciedad y polvo en el
elemento de refrigeración. Si es
n e c e s a r i o l i m p i a r l o , d e b e
desconectar la corriente, extraer la
ventila, situada bajo el condensador
y a s p i r a r e l e l e m e n t o d e
refrigeración usando un cepillo
suave.
El propietario del congelador tiene la
responsabilidad de deshacerse de él
según la normativa aplicable.
Cuando vaya a eliminar un congelador
usado, deberá actuar de forma segura y
respetuosa con el medio ambiente.
Tenga en cuenta la normativa aplicable
sobre tratamiento de residuos. Puede
que existan requisitos / normativas de
obligado cumplimiento.
Puede obtener información acerca de
cómo hacerlo de:
?
Su distribuidor
?
Las autoridades competentes
( a y u n t a m i e n t o , a g e n c i a d e
protección medioambiental u otro
organismo similar).
?
Tratamiento de los productos
eléctricos y electrónicos al final de su
vida