Metacon-Next B.V.
RGS EI(1) 30 - EI(2) 60 - EW 240
12-07-2022
User Manual
art no: 89072 Rev: 1
14
Step 4a: Preparations for installation of c barrel
Degrease and oil the shaft journals before mounting the bearings onto them.
Slide the roll-down protection over the shaft and key using the correct direction of
rotation.
ATTENTION: Check that the roll-down protection is not blocked. If this is the case, it must
be repaired! See Roll-down Protection Data Sheet for further instructions.
On the other side, place the bearing over the shaft.
Tighten one locking screw of the bearing by hand to prevent sliding.
Note: The figure below is for a situation with the drive on the left.
Step 4b: Mounting the c barrel
Place the forks of the forklift at +/- 1/3rd of the width of the curtain (this may require
a 2
nd
forklift), paying attention to possible support points marked on the pallet. Raise
the whole thing using the right lifting equipment. Position the bearings above the
brackets and lower them in a controlled manner.
ATTENTION: Check that the roll-down protection is not blocked. If this is the case, it must
be repaired! See Roll-down Protection Data Sheet for further instructions.
