Metabo PE 15-30, Operating Instructions Manual

Page: 8 / 28

ENGLISH en
8
preservative), some types of wood (like oak and
beech dust), metals, asbestos.
The risk from exposure to such substances will
depend on how long the user or bystanders are
being exposed.
Do not let particles enter the body.
To reduce exposure to these substances: work in a
well ventilated area and wear approved protective
equipment, such as dust masks that are specially
designed to filter out microscopic particles.
Observe the relevant guidelines for your material,
staff, application and place of application (e.g.
occupational health and safety regulations,
disposal).
Collect the generated particles at the source, avoid
deposits in the surrounding area.
Use only suitable accessories. In this way, fewer
particles enter the environment in an uncontrolled
manner.
Use a suitable extraction unit.
Reduce dust exposure with the following measures:
- Do not direct the escaping particles and the
exhaust air stream at yourself or nearby persons
or on dust deposits.
- Use an extraction unit and/or air purifiers.
- Ensure good ventilation of the workplace and
keep it clean using a vacuum cleaner. Sweeping
or blowing stirs up dust.
- Vacuum or wash protective clothing. Do not blow,
beat or brush.
SYMBOLS ON THE TOOLS:
......... Class II Construction
V............. volts
A............. amperes
Hz........... hertz
.../min ..... revolutions per minute
rpm ......... revolutions per minute
~ ............. alternating current
............ alternating current /direct current
n ............. rated speed
See page 2.
1 Spindle locking button
2 Sliding on/off switch
3 Handle
4 Speed adjustment wheel
5 Electronic signal indicator *
6 Dust filter *
7 Bar auxiliary handle *
8 Thumb screws of the bar auxiliary handle *
9 Locking discs of the bar auxiliary handle *
10 Threaded holes on gear housing
* depending on equipment/not in scope of delivery
Before commissioning, check that the rated
mains voltage and mains frequency, as stated
on the type plate match your power supply.
Always install an RCD/GFCI with a maximum
trip current of 30 mA upstream.
Always guide the angle polisher with both
hands on the handles provided.
5.1 PE 15-25: Fitting of bar auxiliary handle
Always work with the bar auxiliary handle (7)
attached! Fit the bar auxiliary handle as shown
(see illustration A, page 2).
- Fit locking discs (9) to the left and right of the gear
housing.
- Fit the bar auxiliary handle (7) at the gear housing.
- Insert the thumb screws (8) left and right into the
bar auxiliary handle (7) and turn gently.
- Adjust the bar auxiliary handle (7) to the required
angle.
- Firmly tighten the thumb screws (8) to the left and
right manually.
5.2 Dust filter (depending on features)
Assembly see page 2, fig. B.
Regularly clean the dust filter. See chapter 8.
Cleaning.
Press in the spindle locking knob (1) only
when the spindle is stationary!
Locking the spindle
Press in the spindle locking button (1) and turn the
spindle by hand until the spindle locking button
engages.
6.1 Installing support plate and sanding
sheet
Only use the adjusting nut supplied with the
support plate.
Place the support plate on the spindle as shown in
the illustration. Screw on sanding sheet with
adjusting nut supplied with support plate. Lock the
spindle. Tighten sanding sheet with support plate
manually in a clockwise direction.
Release by hand or with a two-hole spanner if
necessary.
7.1 Setting speed
The speed can be preset via the thumb-wheel (4)
and is infinitely variable.
4. Overview
5. Initial Operation
6. Installing the tools
7. Use