Tighten the wheel nut by using the supplied wrench as
shown in Fig. 6.
Wheel nut
Wheel
guard
Push button
Wrench
Wheel
washer
Spindle
Depressed
center wheel
Tighten
Fig. 6
CAUTION
Tighten the wheel nut securely and con
fi
rm that
the depressed center wheel does not wobble.
2. Disassembly
To remove the depressed center wheel, simply
reverse the above-mentioned procedure.
MAINTENANCE AND INSPECTION
WARNING
●
Be sure to switch power OFF and disconnect the plug from the receptacle during maintenance and
inspection.
●
Using cracked, deformed or damaged wheels can lead to wheel breakage and resulting serious injury.
1. Replacing the depressed center wheel
Replace the depressed center wheel when it has been
worn out to about 2-3/8" (60mm) in external diameter.
Con
fi
rm that there is no crack or any damage to
the depressed center wheel. If there is a crack or a
transformation in the wheel, replace it immediately.
2. Inspecting the screws
Regularly inspect all screws and ensure that they are
fully tightened. Should any of the screws be loosened,
retighten them immediately.
WARNING
Using this grinder with loosened screws is
extremely dangerous.
3. Con
fi
rm that there is no damage in the wheel guard,
the electrical cord and the housing, etc.
Check that the on/o
ff
switch operates normally.
4. Replacing supply cord
If the supply cord of Tool is damaged, the Tool must
be returned to metabo HPT Authorized Service
Center for the cord to be replaced.
5. Service and repairs
All quality power tools will eventually require
servicing or replacement of parts because of wear
from normal use. To assure that only authorized
replacement parts will be used, all service and
repairs must be performed by a metabo HPT
AUTHORIZED SERVICE CENTER, ONLY.
6. Service parts list
13
English
0000G12VE̲metabo.indb 13
0000G12VE̲metabo.indb 13
2018/03/14 15:15:43
2018/03/14 15:15:43
