19
DETAILED INSTRUCTIONS
ACTIVATION
When setting up the MESI TUBELESS CUFF UNIT for the first time
it needs to be activated. The device will not respond until it is
placed on the MESI LARGE CHARING PLATE and a multifunctional
button illuminates. It is recommended that before first use the MESI
TUBELESS CUFF UNIT is fully charged.
5.1.2
FIRST USE
BATTERY STATUS
The MESI TUBELESS CUFF UNIT comes with an internal battery. To
check the battery status, press multifunctional button on top of each
MESI TUBELESS CUFF UNIT. The button will respond by lighting
up in green or red depending on the battery state. Otherwise, see
the chapter 6.1 CHARGING THE BATTERY for more information on
battery charging.
5.1.3
NOTE
The battery inside a completely new device is most likely not completely
empty and can provide enough power to start the device up. Nonetheless,
please recharge the batteries before first use.
NOTE
When the battery needs to be replaced, the MESI mTABLET UNIT will display
a battery warning. For more information see Chapter 8 ERRORS.
AC/DC POWER
SUPPLY AND
BATTERY
The MESI TUBELESS CUFF UNIT uses two power ...sources: mains
electricity (which uses a AC/DC power supply for charging) and
battery power (which is used while performing measurements).
Connect the AC/DC power supply to a wall socket with a mains
voltage of 100-240V at 50-60Hz and to the connector at the back
of the device.
5.1.4