13
Using number pad keys to run a programme
Programs 0 to 9 can be recalled using the number pad keys.
The following procedure should be used to activate these
programs.
Pre-heat the oven to the required starting temperature by
pressing a TEMPERATURE SETTING PAD. Wait until the
selected temperature light stops flashing.
You can check the oven
temperature by pressing the
Temperature pad again
Press the PROGRAM PAD the
‘P’ will appear in the PROGRAM
DISPLAY.
Avoiding contact with hot surfaces, place the food
item to be cooked in to the oven and close the door.
Press the number pad key you wish to activate (0-9
)
The program number and total cooking time appear
on the display and the first stage indicator will light.
The program will now operate
with the total remaining time
displayed counting down on the
display
(all stage time added together).
When the time reaches “0:00”
an audible signal will be given.
Remove the food from the oven and close the door.
CALL BACK
CALL BACK to review a program allows the program to be reviewed
stage by stage.
Press and hold the CANCEL
PAD.
After a few seconds the TIME
DISPLAY will blank.
Now press one of the pro-
gram numbers
on the NUMBER PAD (0-9).
example:
200°C
example: Program 8
The display will show the contents of that program. This will be shown
with temperature, time and power level illuminated one stage at a time
for a few seconds.
1
2
3
4
RUNNING A PROGRAM
Note:
If the required starting
temperature has not been
reached, an error code is
displayed (E:6).
If this happens remove food
from the oven IMMEDIATELY
and wait until the required
temperature light stops
flashing.
Begin again from Step 2.
At the end of the programmed
cycle, the oven temperature
will revert to that set before the
cycle began
TO STOP THE COOK CYCLE
The cycle may be stopped and
cancelled at any time by pressing
the CANCEL PAD.
PAUSE
The cycle may interrupted by
opening the oven door.
On opening the door the timer will
be held at this point and the light on
the relevant POWER PAD
(microwave or convection) will flash
to indicate an interrupted cycle.
TO CONTINUE the cycle close the
door, an audible warning sounds
as a reminder to press any power
pad to restart the timer.
To review a program use
CALLBACK
