MERLO PANORAMIC, User And Maintenance Manual

Page: 60 / 200

4 - COMMANDS AND INSTRUMENTS
4 - 5
STANDARD SEAT
The instructions for the proper use of the driver's seat, described in this
paragraph, refer to the standard model mounted on your machine. If your
machine is equipped with a seat different from the standard one, please refer
to the relevant instructions in the "OPTIONAL EXTRAS" chapter.
SEAT SHIFT (1)
Lift lever "M", slide the seat forwards or backwards to obtain the required
position and release the lever.
HEIGHT ADJUSTMENT (2)
Sit on the seat and use knob "I" to adjust to the required height; turn the
knob to direction "+" to raise the seat or in direction "-" to lower it.
SUSPENSION ADJUSTMENT (3)
To adjust the seat suspension use handle "A" located at the front side of the
seat frame. Sit on the seat and turn the handle until just the right degree of
suspension is achieved for one's weight. (direction "R" to tighten the
suspension, direction "S" to slacken the suspension)
BACK ADJUSTMENT (4)
Sit with your back firmly against the seat back.
Lift lever "L" upwards to position the back to the required angle.
DOCUMENT HOLDER POCKET (5)
Located behind the seat for holding the machine documentation and small
objects.
ATTENTION! It is forbidden and it is extremely dangerous to
adjust the driver's seat while the vehicle is moving. Position the
driver's seat so that the driver can easily reach the vehicle controls.
Always keep the "INSTRUCTION HANDBOOK FOR OPERATING AND MAINTENANCE" in the document holder pocket
(5).
SAFETY BELT
Seat correctly in the driving seat and check that the safety belt is not kinked. Fasten correctly the safety belt as shown in the
picture.
ADJUSTMENT LOCKING RELEASE
ATTENTION! Before operating the machine always fasten the seat belt and close the lower part of the door
whether machine is stationary or moving.
Adjust the safety belt so that it lays on your hips and not on your stomach.