MERLO PANORAMIC, User And Maintenance Manual

Page: 10 / 200

1 - INTRODUCTION
1 - 8
"CE" COMPLIANCE
Your machine complies with the safety requirements of the European directives (2006/42/CE)
(2004/108/CE) for the protection and safety of people from potential hazards deriving from
machine operation.
To ensure the operator's safety, the cab is built in compliance with the following standards:
-
ISO 3449 FALLING-OBJECT PROTECTIVE STRUCTURES (FOPS)
- ISO 3471 TIP-OVER PROTECTION STRUCTURES (ROPS)
As it complies with the above mentioned requirements of the Safety directive, your machine is
labelled with the "CE" marking.
• MACHINE-PRODUCED VIBRATIONS
Your machine has been designed and built in compliance with international ergonomic standards.
The vibrations sent by the machine to the upper limbs of the operator's body are irrelevant, as the machine operation does not
require a lengthy contact of upper limbs with vibrating parts. In any case, the value of such vibrations does not exceed 2.5
m/sec² Vibrations sent from the machine to the operator's body are less than 0.5 m/sec² (RMS).
• ELECTROMAGNETIC INTERFERENCE
This machine complies with Directive 2004/108/CE on electromagnetic interference which may arise between some electronic
device on the vehicle and further external devices.
Make sure that all extra electric devices fitted on the machine comply with the said standard and that they do not produce any
interference with the vehicle's on-board devices.
Also, make sure they are all labelled with the specific "CE" marking.
• NOISE
AIRBORNE NOISE
This machine complies with Directive 2000/14/CE (Legislative Decree n.262 dated 04 October 2002) concerning "acoustic
emissions in to the environment by machinery and attachments intended for operation outdoors".
The sound power level of your machine is determined on the basis of measurements carried out on an identical machine in
accordance with measurement methods of airborne noise generated by "fork lift trucks with cantilever loading and combustion
engines", whose validity applies at the time of publication of this manual.
The following table shows the sound power level (Lwa) measured:
TYPE OF MEASUREMENT SOUND POWER LEVEL
Guaranteed sound power level (Lwa) 106 dB(A)
During equipment operation, higher noise levels may be measured due to particular working conditions, the surrounding
environment and additional noise sources.
NOTE!
The guaranteed sound power level (Lwa) is also shown on a sticker applied on the inside of the cab window.
NOISE INSIDE THE CAB
Noise inside the cab heard by the operator is detected on the basis of the UNI 12053 standard detailing "sound pressure level
at the operator's position".
The sound pressure level of your machine is determined on the basis of on measurements performed on an identical machine
in accordance with the measurement methods described in the above-mentioned standards, whose validity applies at the time
of publication of this manual.
The following table shows the sound pressure level measured inside the cab (LpAZ):
TYPE OF MEASUREMENT SOUND PRESSURE LEVEL
Sound power level (LpAZ) 77 dB