COPYRIGHT © 2004 MERIT INDUSTRIES, INC.
3 MR. VIPS™ INSTALLATION AND OWNER’S MANUAL PM0441-03
5a. CIRCULAR-SHAPED COILS: When you
are about three feet away, quickly turn
the coil perpendicular to the monitor and
release the trigger.
5b. WAND-SHAPED COILS: When you are
about three feet away, point the wand
away from the monitor and release the
trigger.
Monitor Adjustment Procedure
For adjusting the settings on our monitors,
we suggest following the procedures de-
scribed below. The vertical/horizontal con-
trols and brightness/contrast controls are
located on the monitor control board, inside
the CPU section. Pressing the button la-
beled “SEL” will toggle through the digital
controls. The LED’s indicate which control
is selected. One lit LED corresponds to the
top row of options, while two lit LED’s cor-
responds to the bottom row. The controls
from left to right on the top row are: Con-
trast, Brightness, Horizontal Position, Hori-
zontal Size, Vertical Position, Vertical Size.
The controls from left to right on the bottom
row are: Pincushion, Trapezoid, Parallel,
Zoom and Recall (which sets the display
settings to the original factory defaults).
When the minimum or maximum value has
been reached, the LED’s will flash. Adjust
the monitor controls until the screen looks
as suggested in the following steps.
1.
Set the game to the Quik Match game
screen.
2.
Adjust the vertical and horizontal size
and vertical and horizontal position to
make sure that the game screen fills
the monitor screen and that the game
screen is centered.
3.
Adjust the brightness and contrast con-
trols until the red tiles are a rich red and
the background is black. The numbers
on the tiles should be bright white. (Ad-
justing the brightness and contrast can
also correct for a lack of sharpness.)
General Circuit Board Handling
Information
Before handling any boards, observe the
following procedures:
•
Prevent Electro-Static Discharge by:
1. Storing the boards in the anti-
static bags in which they are
shipped.
2. Removing any static charge
from your body before handling
the boards.
3. Using a ground strap when
handling the boards.
•
When plugging in connectors to the
board, make sure the connector is
inserted straight onto the header and
that the connector covers all header
pins.
•
Do not connect any peripheral device
to the board, if the power is still
connected to the peripheral or if power
is already applied to the board.
CAUTION: Be extremely careful when re-
placing the lithium battery on the mother-
board. There is a danger of explosion if the
battery on the motherboard is incorrectly
replaced. Only replace the battery with the
same type recommended by the manufac-
turer. Dispose of used batteries according
to the manufacturer’s instructions.
Cleaning the Cabinet
•
The cabinet should be cleaned with a
damp cloth and mild detergent. Always
apply the cleaner to the cloth and not
directly on the game. Liquids could
enter the cabinet and damage electron-
ics inside.
Cleaning the Touchscreen Monitor
•
The touchscreen glass should be
cleaned with a damp cloth and isopro-
pyl alcohol or a non-ammonia cleanser.
Do not use any abrasive or vin-
egar-based cleansers, as they will
damage the touchscreen glass.
