25
Appendix: RF DSW Wall Receptacle
In territories where building regulations stipulate that flexible power cables cannot be used within wall spaces, the
DSW600 should be installed in conjunction with the DSW600 Wall Receptacle (available separately). This is a metal
enclosure designed to be installed directly adjacent to the DSW600 to provide a three-way IEC socket to feed the
subwoofer.
B
B
B
Basic
asic
asic
asic installation
installation
installation
installation ssssteps
teps
teps
teps
•
Isolate the mains power supply prior to making any connection.
•
Punch out appropriate holes for cable routing and fit grommets or, if required by the national and local electrical
and building regulations, use cable glands in place of the grommets.
•
Feed the incoming mains cable and the SpeakerLink cable(s) into the RF DSW.
•
Remove the mains terminal box and connect all three wires of the mains cable to the terminal block.
•
Refit the mains terminal box within the housing.
•
Fit the RF DSW to the studwork of the wall.
IIIInstallation
nstallation
nstallation
nstallation instructions
instructions
instructions
instructions
The RF DSW is designed to be installed in the
studwork directly below the DSW600 in-wall
subwoofer as shown here.
It is recommended that the RF DSW is installed
into the studwork along with the subwoofer
assembly. Leaving it to be fitted later increases the
risk of installation issues which may not be easily
rectified by that point.
If an outer layer of plasterboard (sheetrock) is to
be fitted to the wall, it covers the RF DSW.
Therefore, the RF DSW should be installed prior
to the outer layer of plasterboard.
