15
Step 15.
Step 15.
Step 15.
Step 15.
If the grille is to be fitted, slide the 14 grille-
retaining magnets into the 14 openings on the back of
the grille so that the rubber-coated faces of the
magnets are exposed.
Step 16
Step 16
Step 16
Step 16.
If the grille is to be fitted, attach the grille to
the grille frame.
If the grille is not being fitted, and the DSW600 is
being mounted behind a projection screen or any
other type of stretched fabric, there should be a
clearance of at least 30mm between the fabric and the
front surface of the cabinet. This is to allow the drive-
unit to travel its full potential excursion without
making contact with the fabric.
Connections on the electronics module
The DSW600 is powered via a mains inlet socket on the underside of its electronics module. Therefore, a mains feed
terminated with an IEC C13 connector is required within the wall cavity adjacent to where the mains inlet socket will be
located. To ease installation, ensure the mains cable is long enough to allow it to be inserted into the inlet socket once
the electronics module is installed. Approximately 30cm (12in) of spare cable should suffice.
The SpeakerLink connections on the electronics module of the DSW600 carry the audio and control signals for the
product. One SpeakerLink cable is required to connect to the SpeakerLink input socket. Depending on the layout of the
system, a second SpeakerLink cable may be required to be connect to the SpeakerLink output socket. To ease
installation, ensure the cables are long enough to allow them to be inserted into their sockets once the electronics
module is in its final installed position. Approximately 30cm of spare cable should suffice.
Please n
Please n
Please n
Please note
ote
ote
ote
: If two SpeakerLink cables are to be connected to the DSW600, the two cables are distinguished as the
input and output feeds so they can be inserted into the correct respective sockets.
