20
RS232 commands specific to Meridian subwoofers
RS232 commands specific to Meridian subwoofers
RS232 commands specific to Meridian subwoofers
RS232 commands specific to Meridian subwoofers
For the full list of RS232 commands for DSP loudspeakers see
RS232 command set
, page 22.
The non-volatile settings which relate specifically to the installation of the DSW600 are as follows:
Command
Command
Command
Command Parameter
Parameter
Parameter
Parameter What it does
What it does
What it does
What it does
SW
SL
Subwoofer filter controlled by commands received over SpeakerLink.
OFF
Subwoofer deactivated.
1
Sub filter set to 80Hz.
2
Sub filter set to 120Hz.
WI
Sub filter set to “Wide” i.e. the filter is deactivated.
Mm
SL
Sub mode (Music or Movie) controlled by commands over SpeakerLink
MU
Sub mode set to Music.
MO
Sub mode set to Movie.
SG
+/-##
Sub gain set to +/- ##**
** The non-volatile subwoofer gain is only used when the non-volatile SW command is not SL. The range is -15
to +15 in 1dB steps.
RS232 connection options
RS232 connection options
RS232 connection options
RS232 connection options
The DSW600 can receive RS232 commands via the socket on the front-panel of the electronics module or via the
SpeakerLink input socket on the underside of the module. The respective locations of the two connections make each
suitable for particular use-cases.
RS232
RS232
RS232
RS232 via the front
via the front
via the front
via the front----panel socket
panel socket
panel socket
panel socket
The front-panel RS232 allows for the configuration of the DSW600 to suit its role in the system, or to perform firmware
updates.
A cable suitable for connecting to the front-panel RS232 socket, terminated in a female DB9 plug, is available from
authorised Meridian dealers: Meridian part number: PA10824
The socket accepts the longer version of the three-way, 3.5mm (1/8 inch) minijack plug, e.g. Schurter part no.
4802.1300:
The standard minijack plug, as commonly used on headphones and earbuds with a shorter 14mm plug, cannot be
used:
