Section 3 - On the Water
Page 38
90-8M0099741
eng
JUNE 2015
Poor Ventilation
Under certain running or wind conditions, permanently enclosed or canvas enclosed cabins or cockpits with insufficient
ventilation may draw in carbon monoxide. Install one or more carbon monoxide detectors in your boat.
Although the occurrence is rare, on a very calm day, swimmers and passengers in an open area of a stationary boat that
contains or is near a running engine may be exposed to a hazardous level of carbon monoxide.
1. Examples of poor ventilation while the boat is stationary:
a -
Operating the engine when the boat
is moored in a confined space
b -
Mooring close to another boat that
has its engine operating
2. Examples of poor ventilation while the boat is moving:
a -
Operating the boat with the
trim angle of the bow too
high
b -
Operating the boat with no
forward hatches open
(station wagon effect)
Basic Boat Operation (DTS Models)
Launching and Boat Operation
IMPORTANT: Install bilge drain plug prior to launching boat.
Operation Chart
Operation Chart
BEFORE STARTING
AFTER STARTING
WHILE UNDERWAY
AFTER STOPPING
Install bilge drain plug.
Observe all gauges to
check condition of engine.
If not normal, stop engine.
Observe all gauges to
check condition of
engine. If not normal,
stop engine.
Turn ignition key to the
"OFF" position.
Open engine hatch.
Check for fuel, oil, water,
fluid and exhaust leaks.
Listen for the audio
alarm.
Turn battery switch to the
"OFF" position.
Turn battery switch on.
Check shift and throttle
control operation.
Close fuel shut off valve.
Operate bilge blowers.
Check steering operation.
Close seacock, if equipped.
Open fuel shut off valve.
Flush cooling system if in
saltwater.
Open seacock, if equipped.
Drain bilge.
Close the drain system.
Check the engine oil.
Perform all other checks specified by
your dealer and/or boatbuilder.
Listen for audio warning alarm to sound
when the ignition switch is in the "ON"
position.
21626
a
b
a
b
43368
