USB2: USB port
The mainboard has one USB port installed on the rear edge
I/O port array. However, some computer cases have a special
module that mounts USB ports at the front of the case. If you
have this kind of case, use auxiliary USB connectors on USB2
to connect the front-mounted ports to the mainboard.
Pin Signal
Name
Pin Signal
Name
1
3
5
7
9
VREG_FP_USBPWR0
USB_FP_OC0
USB_FP_P0-
US
Ground
2
4
6
8
10
Ground
US
USB_FP_P1-
USB_FP_OC0
VREG_FP_USBPWR0
WOL1/WOM: Wake On LAN/Wake On Modem
If you have installed a LAN card, use the cable provided with
the card to plug into the mainboard WOL1 connector. This en-
ables the Wake On LAN (WOL) feature. When your system is
in a power-saving mode, any LAN signal automatically re-
sumes the system. You must enable this item using the Power
Management page of the Setup Utility.
Pin Signal
Name
1
2
3
5VSB
Ground
SENSE
If you have installed a modem, use the cable provided with
the modem to plug into the mainboard WOM1 connector. This
enables the Wake On Modem (WOM) feature. When your sys-
tem is in a power-saving mode, any modem signal
automatically resumes the system. You must enable this item
using the Power Management page of the Setup Utility. See
page 39 (BIOS configurations) for more information.
31
