Mercury 92-813054A2, Manual

Page: 73 / 97

Section 5 - Maintenance
90-8M0069748
eng
APRIL 2012 Page 65
2. Remove the seawater strainer cover by turning it counterclockwise by hand.
a - Seawater inlet
b - Seawater outlet
c - Seawater strainer cover
3. Remove the strainer from the strainer housing and clean out any debris. Flush the strainer with clean water.
4. Clean out any debris from the strainer housing and flush with clean water.
5. Place the strainer back into strainer housing. Ensure that it is fully and evenly seated into the bottom of the strainer
housing.
6. Inspect the strainer cover's O‑ring seal and replace if damaged or leaking.
7. Install the strainer cover by turning it clockwise by hand. Ensure that the strainer cover O‑ring is properly located and
moderately compressed when the cover is installed. Do not overtighten.
a - Seawater inlet
b - Seawater outlet
c - Seawater strainer cover
8. If the boat is out of the water. Perform an operational inspection of the seawater cooling system after cleaning the seawater
strainer.
a. Cooling water must be supplied to the engine seawater pump. Refer to
Flushing the Seawater System
regarding
cooling water supply when this service is performed with the boat out of the water.
b. Start the engine and allow the seawater system to fill and the engine to reach normal operating temperature.
c. Run the engine at a fast idle between 600 and 1400 RPM. Monitor engine temperature to confirm proper operation of
the cooling system.
d. Inspect the seawater system for leaks maintaining a fast idle engine speed between 600 and 1400 RPM.
e. Tag the keys, record the service in the maintenance log, or otherwise make note that a proper operational inspection
of the seawater system must be performed before returning the boat to service.
25831
a
b
c
25832
a
b
c