- 4 -
Installing Outboard – Non
Thumb Screw Models
1. Attach (tape) engine mounting template (located
in center on this manual) to boat transom.
NOTE: Drill only the top holes for Type 1
Brackets
2. Type 1 Bracket – 30-40 Hp (2 Cyl.) Short Shaft
Versions – Mark the two upper holes and drill
17/32 in. (13.5mm) holes. Set Outboard height
(Step 5) and Drill two 3/8 in. (9.5mm) lower
mounting holes
3. Type 2 Bracket – 30-40-50 Hp – Mark and drill
four 17/32 in. (13.5mm) mounting holes.
4. Type 3 Bracket – 60 Hp – Mark and drill four
17/32 in. (13.5mm) mounting holes.
5. Install the outboard so that the anti-ventilation
plate is in-line or within 1 in. (25 mm) below the
bottom of the boat.
0 - 1 in.
(0 - 25mm)
a
a - Anti Ventilation Plate
6. Fasten outboard with provided mounting hard-
ware shown.
Type 1 Bracket
b
c
d
DRILL
Only the Upper
Holes Using Template
On This Type Bracket.
Mark and drill lower holes
after outboard height is
set.
a
a
d
c
e
Type 2 Bracket
a
d
c
Type 3 Bracket
a
a
e
e
a - 1/2 In. Diameter Bolts (2)
b - 3/8 In. Diameter Bolts (2)
c - Flat Washers (4)
d - Locknuts (4)
e - Marine Sealer - Apply to Shanks of Bolts, Not Threads