Your vehicle was factory-filled with a 50/50 engine coolant and water
concentration. If the concentration of coolant falls below 40% or above
60%, the engine parts could become damaged or not work properly.
A
50/50 mixture of coolant and water provides the following:
•
Freeze protection down to -34°F (-36°C).
•
Boiling protection up to 265°F (129°C).
•
Protection against rust and other forms of corrosion.
•
Proper function of calibrated gauges.
When the engine is cold, check the
level of the engine coolant in the
reservoir.
•
The engine coolant should be at the “FULL COLD” level or within the
“COLD FILL RANGE” as listed on the engine coolant reservoir
(depending upon application).
•
Refer to
scheduled maintenance information
for service interval
schedules.
•
Be sure to read and understand
Precautions when servicing your
vehicle
in this chapter.
If the engine coolant has not been checked at the recommended interval,
the engine coolant reservoir may become low or empty. If the reservoir is
low or empty, add engine coolant to the reservoir. Refer to
Adding
engine coolant
in this chapter.
Note:
Automotive fluids are not interchangeable; do not use engine
coolant, antifreeze or windshield washer fluid outside of its specified
function and vehicle location.
Adding engine coolant
When adding coolant, make sure it is a 50/50 mixture of engine coolant
and distilled water. Add the mixture to the coolant reservoir,
when the
engine is cool,
until the appropriate fill level is obtained.
2009 Sable
(mgo)
Owners Guide, 1st Printing
USA
(fus)
Maintenance and Specifications
304
