Mercury 2006 Mountaineer, Owner'S Manual

Page: 77 / 344

Erasing HomeLink
姞
buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
•
Press and hold the two outer
HomeLink
威
buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
威
is now in the train (or
learning) mode and can be programmed at any time beginning with Step
2 in the
“Programming” section.
Reprogramming a single HomeLink
姞
button
To program a device to HomeLink
威
using a HomeLink
威
button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
威
button. Do NOT release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink
威
button, follow Step 2 in the “Programming”
section.
For questions or comments, contact HomeLink
威
at www.homelink.com
or 1–800–355–3515.
STANDARD MESSAGE CENTER (IF EQUIPPED)
With the ignition in the ON position,
the message center, located on your
instrument cluster, displays
important vehicle information
through a constant monitor of
vehicle systems.
You may select
display features on the message center for a display of status. The
system will also notify you of potential vehicle problems with a display of
system warnings followed by an indicator chime.
2006 Mountaineer (mnt)
Owners Guide (post-2002-fmt)
USA
(fus)
Driver Controls
77