Mercedes-Benz ML 350, Operator'S Manual

Page: 185 / 344

185
Controls in detail
Useful features
Step 4:
왘
Continue to press and hold the inte-
grated signal transmitter button (
3 ,
4 or 5 ) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter
1 every two seconds
until the frequency signal has been
learned. Upon successful training, the
indicator lamp
6 will flash slowly and
then rapidly after several seconds.
왘
Proceed with programming step 5 and
step 6 to complete.
Operation of remote control
왘
Switch on ignition.
왘
Select and press the appropriate inte-
grated signal transmitter button (
3 ,
4 or 5 to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the remote control memory
왘
Switch on ignition.
왘 Simultaneously hold down the signal
transmitter buttons
3 and 5 , for ap-
proximately 20 seconds, or until the in-
dicator lamp
6 flashes rapidly. Do not
hold for longer than 30 seconds.
The codes of all three channels are
erased.
Reprogramming a single integrated
signal transmitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
왘
Press and hold the desired signal trans-
mitter button (
3 , 4 or 5 ). Do not re-
lease the button.
왘 The indicator lamp will begin to flash af-
ter 20 seconds. Without releasing the
integrated signal transmitter button,
proceed with programming starting
with step 3.
i
If you sell your vehicle, erase the codes
of all three channels.