Mercedes-Benz ML 350, Operator'S Manual

Page: 182 / 344

182
Controls in detail
Useful features
Programming or reprogramming the in-
tegrated remote control
Step 1:
왘 Switch on ignition.
Step 2:
왘
If you have previously programmed an
integrated signal transmitter button
and wish to retain its programming,
proceed to step 3. Otherwise, press
and hold the two outer signal transmit-
ter buttons
3 and 5 and release
them only when the indicator light be-
gins to flash after approximately 20
seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory. If you later wish to program a
second and /or third hand-held trans-
mitter to the remaining two signal
transmitter buttons, do not repeat this
step and begin directly with step 3.
Step 3:
왘
Hold the end of the hand-held remote
control transmitter
1 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control locat-
ed on the interior rear view mirror,
keeping the indicator lamp
6 in view.
Step 4:
왘 Using both hands, simultaneously
press the hand-held transmitter
button
2 and the desired integrated
signal transmitter button ( 3 , 4
or 5 ). Do not release the buttons until
completing step 5.
The indicator lamp 6 on the integrat-
ed remote control will flash, first slowly
and then rapidly.
i
For operation in the USA only:
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any inter-
ference received, including interfer-
ence that may cause undesired
operation.
Any unauthorized modification to this
device could void the user’s authority
to operate the equipment.