Programming
Programming buttons
Observe the "Important safety notes"
(
Y
page 295).
Integrated garage door opener in the rear-view
mirror
Garage door remote control
A
is not part of
the integrated garage door opener.
X
The first time before programming, clear
the integrated garage door opener memory
(
Y
page 298).
X
Turn the SmartKey to position 2 in the
ignition lock.
X
Press and hold one of buttons
;
to
?
on
the integrated garage door opener.
After a short time, indicator lamp
:
lights
up yellow.
i
Indicator lamp
:
lights up yellow as soon
as button
;
,
=
or
?
is programmed for
the first time. If the selected button has
already been programmed, indicator
lamp
:
will only light up yellow after ten
seconds have elapsed.
X
Release button
;
,
=
or
?
. Indicator
lamp
:
flashes yellow.
X
Point garage door remote control
A
towards buttons
;
to
?
on the rear-view
mirror at a distance of 2 to 8 inches (5 to
20 cm).
i
The required distance between remote
control
A
and the integrated garage door
opener depends on the garage door drive
system. Several attempts might be
necessary. You should test every position
for at least 25 seconds before trying
another position.
X
Press and hold button
B
on remote control
A
until indicator lamp
:
lights up green.
If indicator lamp
:
lights up green or
flashes, then programming has been
successful.
X
Release button
B
on remote control
A
for
the garage door drive system.
X
If indicator lamp
:
lights up red: repeat
the programming procedure for the
corresponding button on the rear-view
mirror. When doing so, vary the distance
between remote control
A
and the rear-
view mirror.
i
If the indicator lamp flashes green after
successful programming, the garage door
system is using a rolling code. After
programming, you must synchronize the
garage door opener integrated in the rear-
view mirror with the receiver of the garage
door system.
Synchronizing the rolling code
Observe the "Important safety notes"
(
Y
page 295).
Your vehicle must be within reach of the
garage door or exterior gate drive. Make sure
that neither your vehicle nor any persons/
objects are present within the sweep of the
door or gate.
X
Turn the SmartKey to position 2 in the
ignition lock.
X
Press the program button of the door or
gate drive (see the door or gate drive
operating instructions, e.g. under
"programming of additional remote
controls").
296
Features
Stowage
and
features
Summary of Contents for GLK 250 BlueTEC
